About IP Box 3
the new IP Box 3 is a piece of hardware, and software that enables professional phone forensic examiners and phone repair technicians to bruteforce (crack) the 4 or 6 digit passcode on iPhone 7 and iPhone 7 Plus.
This method will keep all data intact once the passcode has been cracked, but can take long amounts of time depending on the length of the pass code.
Also used by phone repair engineers for their customers who forget the passcode on their iPhone 7 or iPhone 7 Plus
The IP Box 3 will Unlock / Restore Password on iPhone 7 / 7 Plus by Password unlock brute force technique and will crack the forgotten screen passcode on iPhone 7 / 7 Plus without losing any data..
The IP Box 3 supports Password Unlock for iPhone 7 and iPhone 7 Plus, iOS 10
Using just ONE IP Box 3 you can brute force up to 3 iPhone 7 or 7 Plus simultaneously.
IP-Box 3 User Manual
This manual will explain how to connect up and use the new IP-Box 3 and brute force the passcode using iOS exploit on the iPhone 7 and 7 Plus
Operating Introduction guide for iPhone 7 and iPhone 7 Plus Passcode brute force unlock using IP-Box 3
Firstly, access the vulnerability interface of limitless input on iPhone, entering password continually till it is deactivated for 15 minutes,
You can then connect PP assistant (or similar iPhone restore tool) to root the system with data protection ( the system version should be rooted higher than the present one so that the vulnerability will occur) If no vulnerability for system 10.32, please root system 10.32 to system 10.33 or Test Vesion 11. Make sure you root system with data protection (Recovery/Backup the data), or your device will stop working. and you can enable your device by the data protection.
Introduction for ports: 7 ports on the equipment, which includes USB 3.0 data cables for 3 ports, side light sensor port, iPhone and Android port for charging, and the side Android prot is for connecting computer to set password or upgrading.
After entering the vulnerability interface of limitless input, connect device with mobile phone, then fasten the light sensor at the top of screen, the first sensor is compatible with first USB port, and so on, you should operate with proper order. Press the first button after equipment 1 shows “connected”, operation is no need after the equipment can input automatically. The equipment will pause automatically if the correct password is matched, it will beep and remind you, the correct password will displayed on screen, enter the password into system by yourself.
Software Setting: The default setting arranges frequently-used at the beginning, it will scan other password automatically without repetition. Default setting is 6-digit password since it is popular, if you need setting 4-digit one, please correct by downloading computer control software. There are options for them. If you need setting your desired password, please use software to generate password.
Answers for common problems:
if you need setting password without connecting computer, long press the corresponding button for 3 seconds. If fail, try again by outage.
If iPhone is powering off automatically during the process, it means the electric current is not enough, we cannot offer charging for iPhone at the same time, so Solution: 1. change to another high-current adapter 2. plug another cable to offer double-charging, if fail , plus another one to offer 3 charging.
- 1 x IP-Box 3
- 3 x Light Sensors For Bruteforce
- 3 x Special USB Lightning Cables For Bruteforce
- 1 x Standard Lightning Cable